Your First 3D Print: A Beginner Checklist From File to Finished Part
The first print is more about learning the workflow than about the object. A short, forgiving model and a careful first layer give you the best chance of success, and each step teaches something you will reuse. Follow this checklist in order.
1. Choose a model that suits a beginner
Pick something small with a wide flat base, no overhangs and no thin spikes, such as a calibration cube or a simple holder. Avoid large figurines at first. Download from a reputable source and read the licence; see 3D Model Licenses Explained.
2. Check the file
Open the STL and look at its dimensions. Make sure the scale is right and the model is oriented the way you expect. Problems such as holes and flipped faces are covered in How to Check an STL File Before You Print, and wrong size or lying-down models in Fix STL Scale, Units and Orientation Problems. A quick look in the converter shows the model from several sides.
3. Prepare the printer
- Clean the build plate with isopropyl alcohol. Fingerprints reduce adhesion.
- Level the bed or run the printer's automatic levelling.
- Load fresh, dry PLA. See PLA vs PETG vs ABS vs ASA vs TPU.
- Check that the nozzle is clean and that the filament feeds smoothly.
4. Slice with safe settings
Use the profile for your printer and material. Typical beginner choices: 0.20 mm layers, 2–3 walls, 15–20% infill, no supports, a brim if the contact area is small. Preview the sliced layers and scrub through them to catch problems before printing. Read Layer Height, Infill and Walls Explained for what each setting does.
5. Watch the first layer
Most failures begin in the first few minutes. The first layer should look like flat, slightly squished lines that touch each other without gaps. If the plastic is stringy and round, the nozzle is too high; if it is transparent and rough, it is too low. Stop and fix it rather than hoping.
6. Keep an eye on it
Stay nearby for the first layers and check back at intervals. Never leave a printer running unattended in a closed space without smoke detection, and keep it away from flammable materials.
7. Remove and finish
Let the plate cool, then flex it or use the recommended method to release the part. Do not pry with a knife towards your hand. Trim stringing, sand lightly and wash if needed.
8. Make a record
Write down the material, temperature and settings that worked. When you later sell or share prints, a short video helps people understand them; see How to Make a 3D Model Turntable Video.
Common first-print mistakes
- Printing at the wrong scale because of a units mismatch.
- Skipping bed cleaning.
- Using wet or old filament.
- Choosing a model that needs supports.
- Changing many settings at once, so you cannot tell which one helped.
When something fails, consult Common 3D Print Problems and How to Fix Them.
Frequently asked questions
How long will the first print take?
A small calibration cube takes from twenty minutes to an hour. Large models take many hours.
Do I need an enclosure?
Not for PLA. Enclosures help with ABS and ASA.